Nissan Rogue I (2007-2010) passenger side outside handle assembly Wiring diagram
This page shows the only wiring diagram for the component.passenger side outside handle assembly, which is found in the car Nissan Rogue I (2007-2010). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram passenger side outside handle assembly (1 of 1)
AS ANTI HIJACK
BACK DOOR OPENER SWITCH ASSEMBLY (REQUEST SWITCH)
BLK WIRE
BLU WIRE
BRN WIRE
CAN-H CAN-L BUZZER REQUEST SW DR IGN SW KEY SW PNK WIRE
DRIVER SIDE OUTSIDE HANDLE ASSEMBLY
FUSE 1
FUSE 14
FUSE 8
FUSE BLOCK (J/B) (BEHIND LEFT END OF DASH)
GRN WIRE
GRY WIRE
HOT AT ALL TIMES
HOT IN ON OR START
INSTRUMENT + INSTRUMENT - PNK WIRE
INSTRUMENT CENTER INSIDE KEY ANTENNA
INTELLIGENT KEY UNIT (BEHIND LEFT END OF DASH)
INTELLIGENT KEY WARNING BUZZER (LEFT FRONT OF ENGINE COMPARTMENT)
KNOB SW DR STATE SW REQUEST SW
LT BLU WIRE
LT GRN WIRE
NCA WIRE
ORG/ WIRE
OUTSIDE KEY ANTENNA
PASS DOOR + PASS DOOR - PNK WIRE
PASSENGER SIDE OUTSIDE HANDLE ASSEMBLY
PASSENGER SIDE SELECTIVE UNLOCK RELAY (BEHIND RIGHT SIDE OF DASH)
PNK WIRE
RED WIRE
REQUEST SW AS
VIO WIRE
WHT WIRE
YEL WIRE
Go to component -> Power door locks circuit, with intelligent key unit (1 of 3) -> PASSENGER SIDE OUTSIDE HANDLE ASSEMBLY
