Nissan Quest III (2003-2009) pedal adjusting control unit (behind left side of dash) wiring diagram
This page shows the only wiring diagram for the component.pedal adjusting control unit (behind left side of dash), which is found in the car Nissan Quest III (2003-2009). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
pedal adjusting control unit (behind left side of dash) wiring diagram (1 of 1)
1 2 3 4 5 6 7 GND
A/T DEVICE (PARK POSITION SWITCH) (UNDER CENTER OF DASH)
BLK WIRE
BLK/WHT WIRE
BLU WIRE
CIRCUIT BREAKER 2 (AT LEFT KICK PANEL)
DETENT SW IGN SW BAT (PTC)
FUSE 1
FUSE BLOCK (J/B) (BEHIND LEFT SIDE OF DASH)
FUSE, FUSIBLE LINK BLOCK (LEFT FRONT OF ENGINE COMPT)
FUSIBLE LINK M
FWD RWD PEDAL ADJUSTING MOTOR (BEHIND LEFT SIDE OF DASH)
GRN WIRE
GRN/WHT WIRE
GRN/YEL WIRE
HOT AT ALL TIMES
HOT IN ON OR START
LT BLU WIRE
OTHER
PED MTR OUT
PEDAL ADJUSTING CONTROL UNIT (BEHIND LEFT SIDE OF DASH)
PEDAL ADJUSTING SWITCH
PPL
RED WIRE
RED/WHT WIRE
RWD ILLUM
WHT WIRE
WHT/BLU WIRE
YEL WIRE
Go to component -> Adjustable pedal circuit -> PEDAL ADJUSTING CONTROL UNIT (BEHIND LEFT SIDE OF DASH)
