Nissan Quest I (1992-1998) for switching diagnostic test mods w/o consult Wiring diagram
This page shows the only wiring diagram for the component.for switching diagnostic test mods w/o consult, which is found in the car Nissan Quest I (1992-1998). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram for switching diagnostic test mods w/o consult (1 of 1)
20 21 TX RX
29 30 28 CLK TX RX
68 65 64 SCICL SCITX SCIRX
A/T CONTROL UNIT (LEFT SIDE OF DASH)
ABS CONTROL MODULE (CENTER OF DASH)
AIRBAG DIAGNOSIS CONTROL MODULE (CENTER OF DASH)
BLK WIRE
BLK/RED WIRE
BLU WIRE
BLU/WHT WIRE
CHECK
DATA LINK CONNECTOR (FOR CONSULT) (LEFT SIDE OF DASH)
DATA LINK CONNECTOR (FOR GST) (LEFT SIDE OF DASH)
ECCS CONTROL MODULE (RIGHT SIDE OF DASH)
FOR SWITCHING DIAGNOSTIC TEST MODS W/O CONSULT
FUSE 29
FUSE 47
FUSE AND FUSIBLE
FUSE BLOCK
GRY/BLU WIRE
HOT AT ALL TIMES
HOT IN ON OR START
J/C 1 (LEFT FRONT OF ENGINE COMPT)
KLINE
L/DIAG WAKE UP
LINK BOX (LEFT FRONT OF ENGINE COMPARTMENT)
RED WIRE
YEL/BLK WIRE
YEL/BLU WIRE
YEL/GRN WIRE
YEL/RED WIRE
Go to component -> Computer data lines -> FOR SWITCHING DIAGNOSTIC TEST MODS W/O CONSULT
