Nissan Murano Z51 facelift (2010-2012) (or pnk) tire press receiver wiring diagram
This page shows the only wiring diagram for the component.(or pnk) tire press receiver, which is found in the car Nissan Murano Z51 facelift (2010-2012). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(or pnk) tire press receiver wiring diagram (1 of 1)
1 2 3 4 GND SIGNAL
10 18 17 TRUNK LID CAN-L CAN-H PNK WIRE
11 13 BAT (FUSE) GND
129 132 TRUNK LID OPENER CANCEL SW PWR WINDOW SW COMM PPL PPL
BAT (F/L)
BCM (BODY CONTROL MODULE) (LEFT SIDE OF DASH)
BLK WIRE
BLK/WHT WIRE
BLU WIRE
COMPUTER DATA LINES SYSTEM
FUSE 10
FUSE BLOCK (J/B) (LEFT END OF DASH)
GRY WIRE
HOT AT ALL TIMES
KEYLESS ENTRY RECEIVER (REAR) PWR SUPPLY
LT GRN WIRE
ORG/ WIRE
PNK 12 13 PNK (OR PNK) WIRE
PNK 90 91 COMPUTER DATA LINES SYSTEM CAN-L CAN-H WIRE
PNK RECEIVER/SENSOR GND WIRE
PPL LOCAL COMM
REMOTE KEYLESS ENTRY RECEIVER (REAR SIDE) (RIGHT END OF DASH)
SOFT TOP CONTROL UNIT
TRUNK LID LOCK ASSEMBLY
TRUNK LID OPENER ACTUATOR
TRUNK LID OPENER CANCEL SWITCH
TRUNK LID OPENER OUT
TRUNK LID OPENER SW
TRUNK LID OPENER SWITCH
TRUNK OPNR ACTUATOR
WHT WIRE
YEL WIRE
Go to component -> Trunk release circuit -> (OR PNK) TIRE PRESS RECEIVER WIRE
