Nissan Murano Z51 facelift (2010-2012) extra in 2 Wiring diagram
This page shows the only wiring diagram for the component.extra in 2, which is found in the car Nissan Murano Z51 facelift (2010-2012). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram extra in 2 (1 of 1)
11 4 BAT (FUSE) ROOM LAMP PNK WIRE
121 124 150 KEY SLOT SWITCH PASS DOOR SW DRIVER DOOR SW
7 19 STEP LAMP OUTPUT ROOM LAMP TIMER CTRL
90 91 PNK CAN-L CAN-H WIRE
BAT (F/L)
BCM (BODY CONTROL MODULE) (LEFT SIDE OF DASH)
BLK WIRE
BLU WIRE
BRN WIRE
COMPUTER DATA LINES SYSTEM
DOOR
DRIVER SIDE FRONT DOOR SWITCH (LEFT "B" PILLAR)
DRIVER SIDE STEP LAMP
DRIVER SIDE VANITY MIRROR LAMP
EXTRA IN 2
FUSE 10
FUSE, FUSIBLE LINK BLOCK (INTEGRAL TO FUSIBLE LINK HOLDER)
FUSIBLE LINK L
GND SW
GRN WIRE
GRY WIRE
HOT AT ALL TIMES
HOT AT ALL TIMES FUSE BLOCK FUSE 9 J/B (LEFT END OF DASH)
KEY BAT
KEY SLOT
LT BLU WIRE
LT GRN WIRE
MAP LAMP
MIRROR LAMP
ON DOOR OFF ON
PASSENGER SIDE FRONT DOOR SWITCH (RIGHT "B" PILLAR)
PASSENGER SIDE STEP LAMP
PASSENGER SIDE VANITY
PNK WIRE
PNK/WHT WIRE
PUSH BUTTON IGNITION SWITCH
RED WIRE
TRUNK ROOM LAMP
WHT WIRE
YEL WIRE
Go to component -> Courtesy lamps circuit -> EXTRA IN 2
