Nissan Murano Z51 facelift 2 (2011-2015) w/o xenon headlamp w/ rearview camera Wiring diagram
This page shows the only wiring diagram for the component.w/o xenon headlamp w/ rearview camera, which is found in the car Nissan Murano Z51 facelift 2 (2011-2015). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram w/o xenon headlamp w/ rearview camera (1 of 1)
13 11 17 18 GND BAT (FUSE) RH TURN SIG LH TURN SIG
146 145 144 143 142 OUTPUT 4 OUTPUT 3 OUTPUT 2 OUTPUT 1 OUTPUT 5 PPL PNK WIRE
BAT (F/L)
BLK WIRE
BLU WIRE
BODY CONTROL MODULE (BCM) (LEFT SIDE OF DASH)
BRN WIRE
COMBINATION SWITCH
COMPUTER DATA LINES SYSTEM
DR DOOR SW PASS DOOR SW
FUSE
FUSE 7
FUSE BLOCK
FUSE, FUSIBLE LINK BLOCK
FUSIBLE LINK L
GRN WIRE
GRY WIRE
HAZARD SW
HAZARD SWITCH
HOT AT ALL TIMES
LEFT FRONT COMBINATION LAMP
LEFT FRONT TURN SIGNAL TURN PARKING LAMP SIGNAL
LEFT PARKING LAMP
LEFT REAR COMBINATION LAMP
LT BLU WIRE
LT GRN WIRE
ORG/ WIRE
PNK PNK WIRE
PNK PPL WIRE
PNK WIRE
RED WIRE
RED/YEL WIRE
SIDE MARKER
STOP
STOP LAMP SWITCH (ON BRAKE PEDAL BRACKET)
TAIL
TURN SIGNAL
W/ XENON HEADLAMP
W/O REARVIEW CAMERA
W/O XENON HEADLAMP W/ REARVIEW CAMERA
WHT WIRE
YEL WIRE
Go to component -> Exterior lamps circuit, except convertible (1 of 2) -> W/O XENON HEADLAMP W/ REARVIEW CAMERA
