Nissan Murano Z51 facelift 2 (2011-2015) request switch Wiring diagram
This page shows the only wiring diagram for the component.request switch, which is found in the car Nissan Murano Z51 facelift 2 (2011-2015). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram request switch (1 of 1)
11 13 BAT (FUSE) GND
90 91 PNK CAN-L CAN-H WIRE
BACK DOOR LOCK ASSEMBLY (LOWER CENTER OF BACK DOOR)
BACK DOOR OPEN REQ SW BACK DR OPEN SW BACK DOOR SW 61 67 66
BACK DOOR SWITCH
BACK DR OPEN OUT
BAT (F/L)
BCM (BODY CONTROL MODULE) (LEFT SIDE OF DASH)
BLK WIRE
BLU WIRE
BRN WIRE
COMPUTER DATA LINES SYSTEM
FUSE 10 (J/B) (LEFT END OF DASH)
FUSE BLOCK
FUSE, FUSIBLE LINK BLOCK (INTEGRAL TO FUSIBLE LINK HOLDER)
FUSIBLE LINK L
HOT AT ALL TIMES
LT BLU WIRE
LT GRN WIRE
OPENER ACTUATOR
OPENER SWITCH
PPL
RED WIRE
REQUEST SWITCH
WHT WIRE
YEL WIRE
Go to component -> Back door circuit, without automatic back door system -> REQUEST SWITCH
