Nissan Kicks I facelift (2020-2024) ignition power supply Wiring diagram
This page shows the only wiring diagram for the component.ignition power supply, which is found in the car Nissan Kicks I facelift (2020-2024). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram ignition power supply (1 of 1)
BLK WIRE
BLU WIRE
CAN L
CAN-H
COMBINATION METER
COMPUTER DATA LINES
COMPUTER DATA LINES SYSTEM
EARLY PRODUCTION
FUSE 28
FUSE 42
FUSE BLOCK (J/B)
FUSIBLE LINK BOX (BATTERY)
FUSIBLE LINK E
GRN WIRE
GROUND
GRY WIRE
HOT AT ALL TIMES
HOT W/ IGNITION RELAY 1 ENERGIZED
HOT W/ IGNITION RELAY-2 ENERGIZED
IGNITION POWER SUPPLY
ILLUMINATION
IPDM E/R (INTELLIGENT POWER DISTRIBUTION MODULE ENGINE ROOM)
LATE PRODUCTION
LED
LEFT REAR INNER SONAR SENSOR
LEFT REAR OUTER SONAR SENSOR
LT BLU WIRE
OFF INDICATOR
PNK CAN-L WIRE
PNK R RANGE SW WIRE
PNK WIRE
PPL
RED WIRE
RIGHT END OF DASH)
RIGHT REAR INNER SONAR SENSOR
RIGHT REAR OUTER SONAR SENSOR
RIL SENSOR SIGNAL
RIR SENSOR SIGNAL
ROL SENSOR SIGNAL
ROR SENSOR SIGNAL
SENSOR GND
SENSOR GROUND
SENSOR PWR
SONAR BUZZER
SONAR CONTROL UNIT (RIGHT END OF DASH)
SONAR SYSTEM OFF SWITCH
SPEAKER PWR
SPEAKER RR SIGNAL
SW INPUT
SYSTEM
TAN WIRE
TCM (TRANSMISSION CONTROL MODULE)
TOP OF TRANSMISSION)
TRANSMISSION RANGE SWITCH
UNIFIED METER CONTROL UNIT (W/ INFORMATION DISPLAY)
WHT WIRE
YEL WIRE
Go to component -> Sonar circuit -> IGNITION POWER SUPPLY
