Nissan Juke I facelift (2014-2019) power socket, map lamp, Wiring diagram
This page shows the only wiring diagram for the component.power socket, map lamp,, which is found in the car Nissan Juke I facelift (2014-2019). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram power socket, map lamp, (1 of 1)
A/C CONTROL (REAR WINDOW DEFOGGER)
ABS ACTUATOR, ELECTRIC UNIT (CONTROL UNIT)
ALTERNATOR
BLK WIRE
BRAKE FLUID LEVEL SWITCH, WASHER LEVEL SWITCH
DONGLE UNIT (CANADA)
DOOR MIRROR REMOTE CONTROL SWITCH
ENGINE CONTROL MODULE (ECM), LEFT FRONT TURN SIGNAL LAMP, FRONT WIPER MOTOR,
EPS CONTROL UNIT
EXCEPT NISMO
FUEL LEVEL SENSOR UNIT
FUEL PUMP
HEATED SEAT RELAY (IF EQUIPPED)
HIGH PRESSURE FUEL PUMP RELAY, FUEL INJECTOR RELAY,
OCCUPANT DETECTION SYSTEM CONTROL UNIT, SEAT HEATER (PASSENGER SIDE FRONT SEAT)
POWER SOCKET, MAP LAMP,
REAR WINDOW DEFOGGER
RIGHT END OF DASH)
RIGHT REAR COMBINATION LAMP, INSIDE KEY ANTENNA (LUGGAGE ROOM) SHIELD
TCM
VDC OFF SWITCH, BODY CONTROL MODULE (BCM),
WOOFER (W/ NAVIGATION),
Go to component -> Ground distribution circuit -> POWER SOCKET, MAP LAMP,
