Nissan Juke I facelift (2014-2019) evap canister vent Wiring diagram
This page shows the only wiring diagram for the component.evap canister vent, which is found in the car Nissan Juke I facelift (2014-2019). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram evap canister vent (1 of 1)
ACCELERATOR PDL
ACCELERATOR PEDAL POSITION SENSOR
ASCD STEERING SW
BLK WIRE
BLU WIRE
BLU/BLK WIRE
BLU/WHT WIRE
BRAKE PEDAL POSITION SWITCH
BRK PDL POSITION SW
BRN WIRE
CAN L
CAN-H
CLUTCH PEDAL
CLUTCH PEDAL POSITION SWITCH
COMPUTER DATA LINES SYSTEM
CRUISE CONTROL SYSTEM
CTRL VALVE
CVT
ECM GND
EVAP CANISTER PURGE VOLUME CONTROL SOLENOID VALVE
EVAP CANISTER VENT
EVAP CANISTER VENT CONTROL VALVE
EVAP CTRL SYS
FUEL INJECTOR RELAY
FUEL TANK
FUSE 3
FUSE 31
FUSE 32
FUSE 36
FUSE 38
FUSE 5
FUSE BLOCK (J/B)
FUSE, FUSIBLE LINK BLOCK
GRN WIRE
GRY WIRE
HIGH PRESSURE FUEL PUMP RELAY
HOT AT ALL TIMES
HOT W/ IGNITION RELAY ENERGIZED
IGNITION SW
LT BLU WIRE
LT GRN WIRE
M/T
ORG/ WIRE
PNK WIRE
POSITION SENS 1
POSITION SENS 2
POSITION SW
PPL
PRESS SENS
PWR SPLY FOR ECM
RED WIRE
SENS GND
SENS PWR SPLY
SENSOR 1
SENSOR 2
SHIELD
STOP LAMP SW
STOP LAMP SWITCH
TAN WIRE
TEMP SENS
WHT WIRE
YEL WIRE
Go to component -> Wiring diagram engine performance 1.6l turbo, except nismo (3 of 6) -> EVAP CANISTER VENT
