Nissan Juke I (2010-2014) fuse holder (w/ daytime running light system) wiring diagram
This page shows the only wiring diagram for the component.fuse holder (w/ daytime running light system), which is found in the car Nissan Juke I (2010-2014). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
fuse holder (w/ daytime running light system) wiring diagram (1 of 1)
ACC/ ON IND
ACC/ON IND
BAT FUSE
BCM (BODY CONTROL MODULE) (LEFT KICK PANEL)
BLK WIRE
BLU WIRE
BLWR RLY CONT
BRN WIRE
CVT
ECM RELAY
ENGINE CONTROLS SYSTEM
FROM FUSE 42 (DIAGRAM 2 OF 3)
FROM FUSE 45 (DIAGRAM 2 OF 3)
FROM FUSE BLOCK (J/B) (DIAGRAM 1 OF 3)
FROM FUSE BLOCK (J/B) (DIAGRAM 2 OF 3)
FROM FUSE, FUSIBLE LINK, RELAY BOX (DIAGRAM 1 OF 3)
FRONT FOG LAMP RELAY
FRONT FOG LAMP RELAY (IF EQUIPPED)
FUSE
FUSE 24
FUSE 43
FUSE 64
FUSE HOLDER
FUSE HOLDER (W/ DAYTIME RUNNING LIGHT SYSTEM)
GRN WIRE
HEADLAMP HIGH RELAY
HEADLAMP LOW RELAY
HEADLIGHTS SYSTEM
IGN PWR SPLY 2 (CVT) CLUTCH INTERLOCK SW (M/T)
IGN RLY (F/B) CONT
IGN RLY IGN PWR (F/B) CONT SPLY 2 (CVT) CLUTCH INTERLOCK SW (M/T)
IGN SW ON
ILLUMINATION
IPDM E/R (INTELLIGENT POWER DISTRIBUTION MODULE ENGINE ROOM)
LT GRN WIRE
M/T
NCA WIRE
PASS DOOR ACC/ON REQ SW IND
PASS DOOR REQ SW
PPL
PUSH BUTTON IGNITION SWITCH (W/ INTELLIGENT KEY)
PUSH SWITCH
RED WIRE
STARTER CONTROL RELAY
STARTER RELAY
STARTING/ CHARGING SYSTEM
TAIL LAMP RELAY
THROTTLE CONTROL MOTOR RELAY
TO FUSE BLOCK (J/B) (DIAGRAM 2 OF 3)
W/ DAYTIME RUNNING LIGHT SYSTEM
W/ INTELLIGENT KEY W/O INTELLIGENT KEY
WHT WIRE
YEL WIRE
Go to component -> Power distribution circuit (3 of 3) -> FUSE HOLDER (W/ DAYTIME RUNNING LIGHT SYSTEM)
