Nissan GT-R I (2007-2011) close open Wiring diagrams
This page contains all the electrical diagrams for the component. close open, in which he is found in the car Nissan GT-R I (2007-2011). You can view various wiring diagrams where this component is used, as well as go to more detailed diagrams to see the complete connection and interaction in the system. All diagrams have links to quickly jump to the corresponding section with the component for easy viewing..
close open wiring diagram (1 of 2)
100 104 103 107 108 99 PNK WIRE
117 110 101 97 102 BNC SW BRAKE SW PNK WIRE
15 11 PNK CAN-L CAN-H WIRE
ACCELERATOR PEDAL POSITION SENSOR
ASCD BRAKE SWITCH (ON BRAKE PEDAL BRACKET)
ASCD STEERING SWITCH
ASCD SW
BLK WIRE
BLU WIRE
BRN WIRE
CANCEL SWITCH
CLOSE
CLOSE OPEN
COMBINATION METER
COMPUTER DATA LINES SYSTEM
COMPUTER DATA LINES SYSTEM PNK WIRE
ECM (ENGINE CONTROL MODULE) (RIGHT END OF DASH)
ELECTRIC THROTTLE CONTROL ACTUATOR (BANK 2) (TOP OF LEFT CYLINDER BANK)
ELECTRIC THROTTLE CONTROL ACTUATOR BANK 1 (TOP OF RIGHT CYLINDER BANK)
ENGINE CONTROLS SYSTEM
FUSE
GNDA-PD/ 74 28 32 15 2 5 20 36 40 PSPRES
GRN WIRE
GRY WIRE
HOT AT ALL TIMES
HOT AT ALL TIMES FUSE BLOCK (J/B) (LEFT KICK PANEL)
HOT IN ON OR START
LEFT "C" PILLAR)
LT BLU WIRE
MAIN (ON/OFF) SWITCH
NCA WIRE
ORG/ WIRE
OUTPUT SHAFT SPEED SENSOR
PNK CAN-L SET IND WIRE
PNK WIRE
PPL
PPL 96 53 50
PWR SPLY CRUISE IND CAN-H
RED WIRE
RESUME/ ACCELERATE
SENS
SENS SIG
SENSOR 1
SENSOR 2
SET/COAST SWITCH
SPIRAL CABLE (COMBINATION SWITCH) (IN STEERING COLUMN)
STOP LP SW SIG
STOPLIGHT SWITCH (ON BRAKE PEDAL BRACKET)
SWITCH
THROTTLE CONTROL MOTOR
THROTTLE POSITION SENSOR
TRANSMISSION UNIT
WHT WIRE
YEL WIRE
Go to component -> Cruise control circuit -> CLOSE OPEN
close open wiring diagram (2 of 2)
BLK WIRE
BLU WIRE
CLOSE
CLOSE OPEN
DEFOGGER SYSTEM
DIODE
DN UP
DOOR MIRROR REMOTE CONTROL SWITCH
DRIVER SIDE DOOR MIRROR
FUSE 19
FUSE BLOCK (J/B) (LEFT KICK PANEL)
GRN WIRE
HOT IN ON OR ACC
ILLUMI- NATION
LT BLU WIRE
MIRROR SWITCH
OFF
OFF OFF
OPEN/CLOSE SWITCH
ORG/ WIRE
PASSENGER SIDE DOOR MIRROR
PPL
RED WIRE
RIGHT LEFT
RIGHT LEFT DN UP
W/O BOSE AUDIO
WHT WIRE
YEL WIRE
Go to component -> Power mirror circuit -> CLOSE OPEN
