Nissan Altima L32 facelift (2009-2013) (integral with throttle body, on intake manifold) wiring diagram
This page shows the only wiring diagram for the component.(integral with throttle body, on intake manifold), which is found in the car Nissan Altima L32 facelift (2009-2013). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(integral with throttle body, on intake manifold) wiring diagram (1 of 1)
106 110 BRAKE BNCSW
12 16 5 6 GND GND
21 22 CAN-H CAN-L PNK WIRE
81 70 CAN-H CAN-L
92 85 GNDA-ASCDSW ASCDSW
ACCEL/RESUME SWITCH
ASCD BRAKE SWITCH (ABOVE BRAKE PEDAL, ON BRACKET)
ASCD STEERING SWITCH
BLK WIRE
BLU WIRE
BRAKE ECU (RIGHT REAR OF ENGINE COMPT)
BRN WIRE
CANCEL SWITCH
COAST/SET SWITCH
COMBINATION METER
COMPUTER DATA LINES SYSTEM
FUSE 3
FUSE 7
FUSE BLOCK (J/B) (BEHIND LEFT END OF DASH)
GRN WIRE
GRY WIRE
HOT AT ALL ALL TIMES
HOT IN ON OR START
JOINT CONNECTOR
JUNCTION
LT BLU WIRE
LT GRN WIRE
MAIN (ON/OFF) SWITCH
PNK WIRE
RED WIRE
SENSOR 1
SENSOR 2
SPIRAL CABLE (IN STEERING COLUMN)
STOP LAMP RELAY 1
STOP LAMP SWITCH (ABOVE BRAKE PEDAL, ON BRACKET)
THROTTLE CONTROL MOTOR ELECTRIC THROTTLE CONTROL ACTUATOR
THROTTLE POSITION SENSOR
WHT WIRE
YEL WIRE
Go to component -> Cruise control circuit, hybrid -> (INTEGRAL WITH THROTTLE BODY, ON INTAKE MANIFOLD)
