Mitsubishi Outlander III (2012-2015) circuit face inter- Wiring diagram

1 2 3 B-27 1 2 PNK WIRE 14 A-17 25 C-28 15 13 PNK WIRE 2 1 3 A-16 2 C-127 20 A-17 31 36 37 48 C-130 BATT SECS PRMS SGND 4 5 C-131 34 C-130 CANH CANL 72 84 104 108 90 91 95 RSB CIRL BACK BRK CANH CANL SW- 75 74 76 79 77 78 B-27 12 11 10 13 16 15 6 B-26 106 109 110 81 B-123 PNK WIRE 8 9 A-17 9 A-16 ACCELERATOR PEDAL POSITION SENSOR (TOP OF ACCELERATOR PEDAL) APSM APSE EV APSS BLK WIRE BLU WIRE BRACKET) BRN WIRE C-304 C-312 C-403 C-410 C-411 C-412 C-417 CAN DRIVE CIRCUIT CAN TRANSCEIVER CIRCUIT CIRCUIT FACE INTER- CLUTCH INTERLOCK SWITCH (M/T) (TOP OF CLUTCH PEDAL ASSEMBLY) CNTS COMBINATION METER COMPUTER DATA LINES SYSTEM CRUISE CONTROL SWITCH CRUISE IND ENGINE CONTROL MODULE (LEFT SIDE OF ENGINE COMPT) ETACS-ECU (LEFT END OF DASH) FUSE 12 FUSE 18 FUSE 2 FUSE 3 FUSE 8 FUSE 2 GRN WIRE GROUND CONNECTOR (C-01) GRY WIRE HALL IC (MAIN) HALL IC (SUB) HOT AT ALL TIMES HOT W/ MFI RELAY ENERGIZED ENGINE COMPARTMENT FUSE 22 RELAY BOX ILL ILL INHN INTERFACE CIRCUIT LED DRIVE CIRCUIT LT BLU WIRE LT GRN WIRE OFF ON CANCEL OFF ON ON/OFF OFF ON RES/ACC ON SET/CST OFF PNK PNK WIRE PNK WIRE POWER DISTRIBUTION SYSTEM PRIMARY PULLEY SPEED SENSOR (ON TRANSAXLE) RED WIRE RELAY ENERGIZED SECONDARY PULLEY SPEED SENSOR (TOP OF TRANSAXLE) SOUND SYSTEMS STOPLIGHT SWITCH (ABOVE BRAKE PEDAL, ON BRACKET) STRL V/S V/SE GNDB THROTTLE ACTUATOR CONTROL MOTOR THROTTLE ACTUATOR CONTROL MOTOR RELAY (IN ENGINE ROOM RELAY BOX) THROTTLE BODY ASSEMBLY (LEFT REAR OF ENGINE) TPSS TPSM TPSE ETV- ETV+ NTSW TRANSMISSION RANGE SWITCH (TOP OF TRANSAXLE) TRANSMISSIONS SYSTEM VEHICLE SPEED SENSOR (M/T) (TOP OF TRANSAXLE) VIO (OR PNK) WIRE VIO WIRE WHT WIRE YEL WIRE