Mitsubishi Outlander II facelift (2009-2013) right front side impact sensor solid state (at base of right "b" pillar) wiring diagram
This page shows the only wiring diagram for the component.right front side impact sensor solid state (at base of right "b" pillar), which is found in the car Mitsubishi Outlander II facelift (2009-2013). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
right front side impact sensor solid state (at base of right "b" pillar) wiring diagram (1 of 1)
BLK WIRE
BLK/WHT WIRE
BLK/YEL WIRE
BLU WIRE
BRN WIRE
BRN/WHT WIRE
CONNECTOR LOCK SWITCH (CONNECTOR COUPLED: ON) (CONNECTOR UNCOUPLED: OFF)
GRN WIRE
LEFT CURTAIN AIR BAG MODULE SQUIB (NEAR TOP OF LEFT "C" PILLAR)
LEFT FRONT SIDE IMPACT SENSOR (AT BASE OF LEFT "B" PILLAR)
LEFT REAR SIDE IMPACT SOLID SENSOR STATE (AT BASE OF LEFT "C" PILLAR)
LT BLU WIRE
LT GRN WIRE
NCA WIRE
OFF ON
OFF RIGHT REAR SIDE IMPACT SENSOR SOLID STATE (AT BASE OF RIGHT "C" PILLAR)
ON OFF
ON OFF OFF
ORG/ WIRE
RED WIRE
RED/BLK WIRE
RIGHT CURTAIN AIR BAG MODULE SQUIB (NEAR TOP OF RIGHT "C" PILLAR)
RIGHT FRONT SIDE IMPACT SENSOR SOLID STATE (AT BASE OF RIGHT "B" PILLAR)
SOLID STATE
WHT WIRE
WHT/BLU WIRE
YEL WIRE
YEL/BLK WIRE
YEL/BLU WIRE
YEL/GRY WIRE
YEL/PNK WIRE
YEL/VIO WIRE
Go to component -> Supplemental restraints circuit (2 of 4) -> RIGHT FRONT SIDE IMPACT SENSOR SOLID STATE (AT BASE OF RIGHT "B" PILLAR)
