Mitsubishi Montero II (1991-2000) indicator ecu (behind right kick panel) wiring diagram
This page shows the only wiring diagram for the component.indicator ecu (behind right kick panel), which is found in the car Mitsubishi Montero II (1991-2000). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
indicator ecu (behind right kick panel) wiring diagram (1 of 1)
2.4L 3.0L
3.0L
ABS ECU (IN RIGHT REAR OF ENGINE COMPT)
AUTO-CRUISE CONTROL ECU (BEHIND LEFT KICK PANEL)
BLK WIRE
BLU WIRE
COMBINATION METER
DATA LINK CONNECTOR 1 (UNDER LEFT SIDE OF DASH, NEAR RELAY BOX)
DATA LINK CONNECTOR 2 (UNDER LEFT SIDE OF DASH, NEAR RELAY BOX)
ENGINE COMPARTMENT RELAY BOX (ON LEFT INNER FENDER PANEL)
ENGINE CONTROL MODULE (BEHIND RIGHT SIDE OF DASH)
ETACS-ECU
GRN/RED WIRE
GRY/RED WIRE
HOT AT ALL TIMES DEDICATED FUSE 5
INDICATOR ECU (BEHIND RIGHT KICK PANEL)
IOD OR STORAGE CONNECTOR (IN ENGINE COMPARTMENT RELAY BOX)
JOINT CONNECTOR 2 (BEHIND RIGHT SIDE OF DASH)
JUNCTION BLOCK (BEHIND LEFT SIDE OF DASH)
LT GRN/YEL WIRE
REAR DIFFERENTIAL LOCK ECU (ON RIGHT REAR QUARTER PANEL, BEHIND TRIM)
RED WIRE
RED/BLK WIRE
SRS-ECU (BEHIND CENTER CONSOLE)
VEHICLE SPEED SENSOR (ON TRANSMISSION TAILSHAFT)
YEL WIRE
YEL/BLK WIRE
YEL/ORG WIRE
YEL/RED WIRE
YEL/VIO WIRE
YEL/WHT WIRE
Go to component -> Computer data lines -> INDICATOR ECU (BEHIND RIGHT KICK PANEL)
