Mitsubishi Lancer X facelift (2011-2015) interface analog Wiring diagram
This page shows the only wiring diagram for the component.interface analog, which is found in the car Mitsubishi Lancer X facelift (2011-2015). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram interface analog (1 of 1)
1 C-309
17 C-311 PNK WIRE
17 F-30 HATCHBACK
5 C-316
6 7 D-15 (NOT USED) PNK WIRE
7 C-301 6
7 D-11
7 D-15
8 7 16 12 5 C-313 13 C-315
8 7 D-11 (NOT USED) PNK WIRE
8 F-23 SEDAN
9 C-301
ANALOG
BLK WIRE
BLK/RED WIRE
BLU WIRE
BLU/WHT WIRE
BRN WIRE
BRN/WHT WIRE
CAN DRIVE
CAN DRIVE CIRCUIT
CIRCUIT
CIRCUIT INTERFACE
COMPUTER DATA LINES SYSTEM
D-15
ETACS-ECU (ON REAR OF JUNCTION BLOCK, BEHIND LEFT END OF DASH)
FUSIBLE LINK 34
FUSIBLE LINK BOX
GRN WIRE
GRY WIRE
HATCHBACK PNK WIRE
HOT AT ALL TIMES
INTERFACE ANALOG
INTERFACE CIRCUIT
KEY REMINDER SWITCH (W/O KOS)
LEFT REAR DOOR SWITCH (IN LEFT "C" PILLAR)
LIFT GATE SWITCH
LUGGAGE COMPARTMENT LIGHT
NCA WIRE
OFF
ON OFF
ON ON OFF OFF
ON ON OFF OFF OFF
ON ON ON OFF OFF OFF
ON ON ON ON OFF OFF OFF OFF OFF OFF
PNK WIRE
RED WIRE
RED/WHT WIRE
RIGHT REAR DOOR SWITCH (IN RIGHT "C" PILLAR)
SEDAN PNK WIRE
TRUNK LID LOCK ACTUATOR (CENTER REAR OF TRUNK LID)
WHT WIRE
YEL WIRE
Go to component -> Courtesy lamps circuit, except evolution (1 of 2) -> INTERFACE ANALOG
