Mitsubishi Lancer X facelift (2011-2015) (in driver's seat) driver's air bag module squib wiring diagram
This page shows the only wiring diagram for the component.(in driver's seat) driver's air bag module squib, which is found in the car Mitsubishi Lancer X facelift (2011-2015). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(in driver's seat) driver's air bag module squib wiring diagram (1 of 1)
24 C-122 14 C-128
3 A-33
ACCELERO METER
BLK WIRE
BLU WIRE
BRN WIRE
CLOCK SPRING (IN STEERING COLUMN)
CONNECTOR LOCK SWITCH (CONNECTOR COUPLED: ON) (CONNECTOR UNCOUPLED: OFF)
GRN WIRE
GRY WIRE
LT BLU WIRE
NCA WIRE
OFF
OFF ON
OFF ON 1 2 3 4
OFF ON 11 12
OFF ON 5 6
OFF ON 7 8
OFF ON 9 10
ON OFF
ON OFF OFF ON
ON OFF OFF ON ON
RED WIRE
RED/BLU WIRE
RED/YEL WIRE
RIGHT FRONT IMPACT SENSOR (RIGHT FRONT SIDE OF ENGINE COMPT)
SRS ECU (BEHIND LOWER CENTER OF DASH)
WHT WIRE
WHT/BLK WIRE
YEL WIRE
YEL/BLK WIRE
YEL/BLU WIRE
YEL/GRN WIRE
YEL/GRY WIRE
YEL/RED WIRE
YEL/VIO WIRE
Go to component -> Supplemental restraints circuit, except evolution (4 of 4) -> (IN DRIVER'S SEAT) DRIVER'S AIR BAG MODULE SQUIB
