Mitsubishi Lancer X facelift (2011-2015) brake fluid level switch Wiring diagram
This page shows the only wiring diagram for the component.brake fluid level switch, which is found in the car Mitsubishi Lancer X facelift (2011-2015). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram brake fluid level switch (1 of 1)
2 15 16 D-11
5 C-35
6 C-35
ABS
ABS IND.
ASC IND
ASC OFF SWITCH
AWC SWITCH
AWC-ECU (LEFT SIDE OF DASH)
BLK WIRE
BLK/RED WIRE
BLK/WHT WIRE
BLOCK, BEHIND LEFT END OF DASH)
BLU WIRE
BLU/WHT WIRE
BRAKE FLUID LEVEL SWITCH
BRAKE IND
BRAKE/
BRN WIRE
BRN/WHT WIRE
C-22
C-301
C-304
C-311
C-312
C-313
C-315
C-317
CIRCUIT
COMBINATION METER
COMPUTER DATA LINES SYSTEM
D-11
ETACS-ECU (ON REAR OF JUNCTION
FUSE 2
FUSE 8
FUSE 9
FUSE FUSE
GRN WIRE
GRN/WHT WIRE
GRY WIRE
HOT AT ALL TIMES
ILLUM
INTERFACE
J/C 1
LCD
LED DRIVE CIRCUIT
LT BLU WIRE
LT GRN WIRE
NCA WIRE
PARKING BRAKE SWITCH (UNDER CENTER CONSOLE)
PNK WIRE
PRESSURE SENSOR (UNDER RIGHT REAR OF LUGGAGE COMPT)
PROPORTIONING VALVE (ACD CONTROL) (RIGHT REAR CORNER OF VEHICLE)
RED/WHT WIRE
RELAY ENERGIZED
RHEOSTAT
SNOW
STEERING WHEEL SENSOR (IN STEERING WHEEL)
STOPLIGHT SWITCH (UNDER LEFT SIDE OF DASH)
TRANSCEIVER CAN
VIO WIRE
WHT/RED WIRE
YEL/BLK WIRE
Go to component -> 2.0l turbo, anti-lock brakes circuit, except evolution with active skid control (2 of 2) -> BRAKE FLUID LEVEL SWITCH
