Mitsubishi Lancer X (2007-2010) solid state left rear tire pressure sensor Wiring diagram
This page shows the only wiring diagram for the component.solid state left rear tire pressure sensor, which is found in the car Mitsubishi Lancer X (2007-2010). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram solid state left rear tire pressure sensor (1 of 1)
& RECEIVER
18 17 15 14 5 4 8 7 21 20 (W/O KOS) (W/ KOS)
BLK WIRE
BLK/BLU WIRE
BLK/WHT WIRE
BRN WIRE
BRN/WHT WIRE
C-301
C-317
CAN DRIVE CIRCUIT
CAN TRANSCEIVER CIRCUIT
COMBINATION METER
COMPUTER DATA LINES SYSTEM
ETACS-ECU (BEHIND LEFT END OF DASH)
FUSE
GRN WIRE
GRN/RED WIRE
GRY WIRE
HOT AT ALL TIMES
HOT W/ IGNITION 1 RELAY ENERGIZED
INTERFACE CIRCUIT
JOINT CONNECTOR 6 (BEHIND RIGHT SIDE OF DASH)
KOS-ECU (W/ KOS) (UNDER LEFT SIDE OF DASH)
LCD (TIRE PRESSURE)
NCA WIRE
PNK WIRE
PRESSURE SENSOR
RECEIVER ANTENNA ASSEMBLY (LEFT SIDE OF LUGGAGE COMPT)
RED WIRE
RED/WHT WIRE
SOLID STATE LEFT FRONT TIRE PRESSURE SENSOR
SOLID STATE LEFT REAR TIRE PRESSURE SENSOR
SOLID STATE RIGHT FRONT TIRE
SOLID STATE RIGHT REAR TIRE
VIO WIRE
W/ KOS
W/O KOS
WHT WIRE
WHT/BLU WIRE
WIRELESS CONTROL MODULE (W/O KOS) (ON STEERING COLUMN)
YEL WIRE
YEL/GRN WIRE
YEL/GRY WIRE
Go to component -> Tire pressure monitoring circuit, evolution -> SOLID STATE LEFT REAR TIRE PRESSURE SENSOR
