Mitsubishi Lancer IX (2000-2007) stop tail turn rear combination light assembly Wiring diagram
This page shows the only wiring diagram for the component.stop tail turn rear combination light assembly, which is found in the car Mitsubishi Lancer IX (2000-2007). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram stop tail turn rear combination light assembly (1 of 1)
ANTI-LOCK BRAKES SYSTEM
ASSEMBLY
BACK-UP LAMPS CIRCUIT
BLK WIRE
BLU WIRE
BRN WIRE
CRUISE CONTROL SYSTEM
DEDICATED FUSE 10
DEDICATED FUSE 13
DEDICATED FUSE 20
DEDICATED FUSE 21
DEDICATED FUSE 22
ENGINE COMPARTMENT RELAY BOX (ON LEFT SIDE OF ENGINE COMPARTMENT)
FRONT ECU
GRN WIRE
GRN/RED WIRE
GRN/YEL WIRE
HIGH MOUNTED STOP LIGHT (REAR SHELF)
HIGH- MOUNTED STOP LIGHT (REAR SPOILER)
HOT AT ALL TIMES
INSTRUMENT CLUSTER
JOINT CONNECTOR
JOINT CONNECTOR 1 (BEHIND CENTER OF DASH)
JOINT CONNECTOR 2 (BEHIND
JUNCTION BLOCK, BEHIND LEFT END OF DASH)
LEFT
LEFT FRONT TURN SIGNAL LIGHT
LEFT LICENSE PLATE LIGHT RIGHT LICENSE PLATE LIGHT
LEFT POSITION LIGHT RIGHT POSITION LIGHT
LEFT SIDE TURN SIGNAL LIGHT
LT GRN WIRE
NCA WIRE
ON OFF
ORG/ WIRE
POWER SOURCE
RED WIRE
RED/BLK WIRE
RIGHT REAR COMBINATION LIGHT
STOP TAIL TURN
STOP TAIL TURN REAR COMBINATION LIGHT ASSEMBLY
STOPLIGHT SWITCH (ABOVE BRAKE PEDAL, ON BRACKET)
TAILLIGHT RELAY
VIO WIRE
WHT WIRE
WHT/BLK WIRE
YEL WIRE
Go to component -> Exterior lamps circuit, except evolution (1 of 2) -> STOP TAIL TURN REAR COMBINATION LIGHT ASSEMBLY
