Mitsubishi Eclipse IV facelift (2008-2011) hall ic 1 pulse sensor Wiring diagram
This page shows the only wiring diagram for the component.hall ic 1 pulse sensor, which is found in the car Mitsubishi Eclipse IV facelift (2008-2011). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram hall ic 1 pulse sensor (1 of 1)
BLK WIRE
BLU/RED WIRE
COMPUTER DATA LINES SYSTEM
ENGINE COMPARTMENT RELAY BOX (LEFT SIDE OF ENGINE COMPT)
ETACS-ECU
FUSE 12
FUSE 2
FUSE 21
FUSE 22
GRN/ORG WIRE
GRN/RED WIRE
GRN/YEL WIRE
HALL IC 1 PULSE SENSOR
HALL IC 2
HOT AT ALL TIMES
HOT IN ON
HOT IN ON OR START
JOINT CONNECTOR 2 (BEHIND LEFT SIDE OF DASH)
JUNCTION BLOCK (UNDER LEFT END OF DASH)
LT GRN WIRE
OFF
OPEN OFF CLOSE/ DOWN
ORG/BLK WIRE
RED WIRE
RED/BLU WIRE
RED/WHT WIRE
SUNROOF ECU
SUNROOF MOTOR
SUNROOF MOTOR ASSEMBLY (ON FRONT CENTER OF ROOF)
SUNROOF SWITCH
WHT WIRE
Go to component -> Sunroof circuit -> HALL IC 1 PULSE SENSOR
