Contents Section: Cooling System (Mechanical) All sections

Engine Cooling: Specifications Mitsubishi Eclipse IV рестайлинг

FASTENER TIGHTENING SPECIFICATIONS

ITEMSPECIFICATION
Cylinder block drain plug < 2.4L Engine >44 +/- 5 N. m (33 +/- 3 ft-lb)
Cylinder block drain plug < 3.8L Engine >39 +/- 5 N. m (29 +/- 3 ft-lb)
Radiator
Front end structure bar boltM8 X 1011 +/- 2 N. m (98 +/- 17 in-lb)
M8 X 2022 +/- 4 N. m (16 +/- 3 ft-lb)
Thermostat < 2.4L Engine >
Harness bracket bolt11 +/- 1 N. m (98 +/- 8 in-lb)
Water inlet fitting bolt13 +/- 2 N. m (111 +/- 22 in-lb)
Thermostat < 3.8L Engine >
Control harness bolt5.0 +/- 1.0 N. m (44 +/- 9 in-lb)
Water inlet fitting bolt19 +/- 1 N. m (14 +/- 1 ft-lb)
Water Hose And Water Pipe < 2.4L Engine >
Radiator lower hose clamp bolt11 +/- 1 N. m (98 +/- 8 in-lb)
Thermostat case bolt24 +/- 4 N. m (18 +/- 3 ft-lb)
Water hose clamp bolt11 +/- 1 N. m (98 +/- 8 in-lb)
Water inlet pipe bolt13 +/- 2 N. m (111 +/- 22 in-lb)
Water outlet fitting bolt13 +/- 2 N. m (111 +/- 22 in-lb)
Water Hose And Water Pipe < 3.8L Engine >
Capacitor bolt5.0 +/- 1.0 N. m (44 +/- 9 in-lb)
Engine coolant temperature sensor30 +/- 9 N. m (22 +/- 7 ft-lb)
Thermostat housing bolt19 +/- 1 N. m (14 +/- 1 ft-lb)
Water inlet pipe bolt11 +/- 1 N. m (98 +/- 8 in-lb)
Water Pump < 2.4L Engine >
Water pump bolt14 +/- 1 N. m (120 +/- 13 in-lb)
Water Pump < 3.8L Engine >
Water pump boltM842 +/- 8 N. m (31 +/- 6 ft-lb)
M1024 +/- 3 N. m (18 +/- 2 ft-lb)
Water pump bracket bolt24 +/- 3 N. m (18 +/- 2 ft-lb)

FASTENER TIGHTENING SPECIFICATIONS

SERVICE SPECIFICATION

ITEMSTANDARD VALUELIMIT
Fan control moduleCondenser fan motor connector voltage VWhen the A/C switch is off Measure the fan control module-side connector1 or less
When the A/C switch is "ON" position Measure the fan control module-side connectorRepeat 8.2 +/- 2.6 and Battery positive voltage +/- 2.6
Fan control module connector voltage VWhen the ignition switch is "ON" position Measure the harness-side connectorBattery positive voltage
High-pressure valve opening pressure of radiator cap kPa (psi)93 - 123 (14 - 18)Minimum 83 (12)
ThermostatValve opening temperature of thermostat °C (°F)82 +/- 1.5 (180 +/- 3)
Full-opening temperature of thermostat °C (°F)95 (203)
Valve lift mm (in)2.4L Engine8.5 (0.33) or more
3.8L Engine9.0 (0.35) or more

SERVICE SPECIFICATION

CAPACITIES

ITEMQUANTITY dm 3 (qt)
Long life antifreeze coolant or an equivalent2.4LM/T8.8 (9.3)
A/T8.7 (9.2)
3.8LM/T8.1 (8.6)
A/T8.0 (8.5)

CAPACITIES SERVICE SPECIFICATION