Mitsubishi Diamante II (1995-2005) oil pressure indicator wiring diagram
This page shows the only wiring diagram for the component.oil pressure indicator, which is found in the car Mitsubishi Diamante II (1995-2005). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
oil pressure indicator wiring diagram (1 of 1)
7 1 DATA LINK CONNECTOR (UNDER LEFT SIDE OF DASH, NEAR STEERING COLUMN)
ASSIST ECM (UNDER RIGHT SIDE OF DASH, NEAR KICK PANEL)
BLK WIRE
BLK/WHT WIRE
BLU WIRE
BLU/RED WIRE
BRN WIRE
BRN/WHT WIRE
CENTER WARNING DISPLAY
CENTER WARNING DISPLAY SWITCH SET
CHARGE INDICATOR
COMPUTER DATA LINES SYSTEM
DEDICATED FUSE 1
DEDICATED FUSE 13
ENGINE COMPARTMENT RELAY BOX (ON LEFT FRONT FENDER)
ETACS-ECU
GENERATOR
GRN WIRE
GRN/WHT WIRE
GRY/RED WIRE
HOT AT ALL TIMES
HOT IN ACC OR RUN
HOT IN RUN OR START
HOT WITH TAILLIGHT RELAY ENERGIZED
INSTRUMENT PANEL ECM (BEHIND LEFT SIDE OF DASH)
JOINT CONNECTOR 5 (BEHIND LEFT SIDE OF DASH)
JUNCTION BLOCK (BEHIND LEFT SIDE OF DASH)
MULTI- PURPOSE FUSE 13
MULTI-PURPOSE FUSE 6
OIL PRESSURE INDICATOR
OIL PRESSURE SWITCH (RIGHT FRONT OF ENGINE COMPARTMENT)
PNK WIRE
RED WIRE
RED/BLK WIRE
SOLID STATE
WHT WIRE
WHT/RED WIRE
YEL WIRE
Go to component -> Message center circuit -> OIL PRESSURE INDICATOR
