Mitsubishi Diamante I (1989-1997) interior lights system (junction block) wiring diagram
This page shows the only wiring diagram for the component.interior lights system (junction block), which is found in the car Mitsubishi Diamante I (1989-1997). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
interior lights system (junction block) wiring diagram (1 of 1)
58 24 (1996) (1995)
BLK WIRE
BLU WIRE
DATA LINK CONNECTOR (PARTIAL) (LEFT I/P)
DEDICATED FUSE 11
DEDICATED FUSE 12
DEFOGGER
DEFOGGER RELAY (BELOW (CENTER OF I/P)
DEFOGGER SWITCH
ENGINE CONTROL MODULE (DOHC) (RIGHT SIDE OF I/P)
ETACS UNIT (CENTER (OF I/P)
GRN WIRE
HOT AT ALL TIMES
HOT IN ON OR ACC
HOT IN ON OR START
IDLE-UP
IDLE-UP DIODE (BEHIND JUNCTION BLOCK, STRAPPED TO HARNESS)
ILLUM- INATION LAMP
INTERIOR LIGHTS SYSTEM (JUNCTION BLOCK)
INTERIOR LIGHTS SYSTEM (RHEOSTAT)
JUNCTION BLOCK (LEFT I/P)
JUNCTION BLOCK (LEFT SIDE OF I/P)
LEFT REMOTE CONTROLLED MIRROR
MIRROR HEATER
MULTI- PURPOSE FUSE 11
MULTI- PURPOSE FUSE 3
MULTI-PURPOSE FUSE 19
NCA WIRE
ON INDICATOR
ORG/ WIRE
PASSENGER COMPARTMENT RELAY BOX (LEFT SIDE OF I/P)
RED WIRE
RED/BLK WIRE
RIGHT REMOTE CONTROLLED MIRROR
STORAGE CONNECTOR (IN ENGINE COMPARTMENT RELAY BOX)
YEL WIRE
Go to component -> Defogger circuit -> INTERIOR LIGHTS SYSTEM (JUNCTION BLOCK)
