Mercury Villager I (1992-1998) starter assembly hold pull-in wiring diagram
This page shows the only wiring diagram for the component.starter assembly hold pull-in, which is found in the car Mercury Villager I (1992-1998). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
starter assembly hold pull-in wiring diagram (1 of 1)
BATTERY
BLK WIRE
BLK/RED WIRE
BLK/YEL WIRE
ENGINE COMPARTMENT FUSE/RELAY PANEL
ENGINE COMPARTMENT FUSE/RELAY PANEL INHIBIT RELAY
FUSE 30
FUSE LINK 1
FUSE LINK 2
HOT IN START OR RUN
I/P FUSE/ RELAY PANEL
IGN FUSE
IGNITION SWITCH
LOCK
LT GRN WIRE
LT GRN/BLK WIRE
NCA WIRE
OFF
RED WIRE
RED/WHT WIRE
RUN WIRE
STARTER ASSEMBLY HOLD PULL-IN
TRANSMISSION RANGE (TR) SENSOR (LEFT SIDE OF ENGINE, ON FRONT OF TRANSAXLE)
WHT WIRE
WHT/PPL WIRE
YEL WIRE
Go to component -> Starting circuit, without anti-theft -> STARTER ASSEMBLY HOLD PULL-IN
