Mercury Villager I (1992-1998) headlamp on input wiring diagram
This page shows the only wiring diagram for the component.headlamp on input, which is found in the car Mercury Villager I (1992-1998). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
headlamp on input wiring diagram (1 of 1)
BATTERY
BLK WIRE
BLU WIRE
BLU/ORG WIRE
BRN WIRE
CHIME CONTROL
ENGINE COMPARTMENT FUSE/RELAY PANEL
ENGINE COMPARTMENT FUSE/RELAY PANEL J/C 2
FUSE 21
FUSE 29
FUSE 30
GRN WIRE
GROUND
GROUND GROUND
HEAD
HEAD- LAMP SWITCH
HEADLAMP ON INPUT
HOT AT ALL TIMES
HOT IN ACC OF RUN
HOT IN START OR RUN
I/P FUSE/ RELAY PANEL FUSE 5
IGNITION
IGNITION KEY SWITCH
INSTRUMENT CLUSTER SEAT BELT LAMP
J/C 1 (BEHIND LEFT SIDE OF I/P)
J/C 3 (BEHIND TOP LEFT SIDE OF I/P)
KEY IN IGNITION INPUT
LEFT DOOR JAMB SWITCH
LT GRN WIRE
NCA WIRE
OFF
ORG/ WIRE
ORG/BLK WIRE
PARK
PPL/WHT WIRE
RED WIRE
RED/GRN WIRE
SEAT BELT SWITCH
SEAT BELT SWITCH INPUT DOOR SWITCH INPUT
SEC FUSE
SMART ENTRY CONTROL (SEC)/
TIMER MODULE (CENTER OF I/P)
WARNING CHIME
Go to component -> Warning system circuits -> HEADLAMP ON INPUT
