Mercury Tracer I (1991-1999) slip ring assembly (top of steering column) wiring diagram
This page shows the only wiring diagram for the component.slip ring assembly (top of steering column), which is found in the car Mercury Tracer I (1991-1999). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
slip ring assembly (top of steering column) wiring diagram (1 of 1)
120 OHMS
2200 OHMS
680 OHMS
ASC FUSE
BLK WIRE
BLU WIRE
BRAKE ON/OFF (BOO) SWITCH (ON BRAKE PEDAL SUPPORT)
BRAKE PRES- SURE SWITCH (BEHIND LEFT SIDE OF I/P)
CLUTCH PEDAL POSITION SWITCH (TOP OF CLUTCH PEDAL SUPPORT)
COAST
GRN WIRE
GRN/YEL WIRE
HOT AT ALL TIMES
HOT IN START OR RUN
I/P FUSE PANEL
M/T A/T
NCA WIRE
OFF
RED/BLU WIRE
RED/YEL WIRE
RESUME
SET/ ACCEL
SLIP RING ASSEMBLY (TOP OF STEERING COLUMN)
SPEED CONTROL AMPLIFIER (RIGHT FRONT SIDE OF ENGINE)
SPEED CONTROL SWITCH ASSEMBLY (IN STEERING WHEEL)
STOP FUSE
VEHICLE SPEED SENSOR (VSS) (REAR OF TRANS)
WHT WIRE
WHT/BLK WIRE
YEL WIRE
Go to component -> Cruise control circuit -> SLIP RING ASSEMBLY (TOP OF STEERING COLUMN)
