Mercury Tracer I (1991-1999) driver air bag Wiring diagram
This page shows the only wiring diagram for the component.driver air bag, which is found in the car Mercury Tracer I (1991-1999). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram driver air bag (1 of 1)
8 9 PASS AIR BAG
AIR BAG DIAGNOSTIC MONITOR (CENTER DASH PANEL)
AIR BAG INDICATOR
BLK WIRE
BLK/BLU WIRE
BLK/GRN WIRE
BLK/RED WIRE
BLK/WHT WIRE
BLK/YEL WIRE
BLU/RED WIRE
BLU/WHT WIRE
BLU/YEL WIRE
DRIVER AIR BAG
DRVR AIR BAG
ENGINE COMPARTMENT FUSE BOX
ENGINE FUSE
GND 4 5 AIR BAG IND
GRN WIRE
GRN/RED WIRE
GRN/YEL WIRE
HOT AT ALL TIMES FUEL INJ FUSE
HOT IN RUN OR START I/P FUSE PANEL
INSTRUMENT CLUSTER
JOINT CONN #11
JOINT CONN #12
JOINT CONNECTOR 3
JOINT CONNECTOR 4
L CRASH SENS
LEFT FRONT PRIMARY CRASH SENSOR (LEFT FRONT OF ENG COMPT, NEAR RADIATOR SUPPORT)
LEFT KICK PANEL SAFING SENSOR (LEFT KICK PANEL)
NCA WIRE
PASS AIR BAG 10 11 DRVR AIR BAG
PASSENGER AIR BAG
PNK/GRN WIRE
PPL
PPL SAFING SENS
PPL/WHT WIRE
PWR (BAT)
PWR (RUN) 2 3 R CRASH SENS
R CRASH SENS
RED WIRE
RIGHT FRONT PRIMARY CRASH SENSOR
SAFING SENS
SHORT BAR
SLIP RING ASSEMBLY
WHT/GRN WIRE
WHT/ORG WIRE
YEL WIRE
YEL/RED WIRE
Go to component -> Supplemental restraint circuit -> DRIVER AIR BAG
