Mercury Tracer I (1991-1999) clutch start switch jumper (behind left side of i/p) wiring diagram
This page shows the only wiring diagram for the component.clutch start switch jumper (behind left side of i/p), which is found in the car Mercury Tracer I (1991-1999). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
clutch start switch jumper (behind left side of i/p) wiring diagram (1 of 1)
A/T
BATTERY
BLK WIRE
BLK/LT GRN WIRE
BLK/RED WIRE
BLK/WHT WIRE
BLU/RED WIRE
CLUTCH
CLUTCH START SWITCH JUMPER (BEHIND LEFT SIDE OF I/P)
ENGINE COMPART- MENT FUSE BOX
ENGINE COMPARTMENT FUSE BOX
GROUND DISTRIBUTION SYSTEM
HOT AT ALL TIMES
I/P FUSE PANEL
IGNITION SWITCH
INHIBIT RELAY (BEHIND LEFT SIDE OF I/P)
INSTRUMENT CLUSTER
LOCK
LT GRN WIRE
M/T
MAIN MAXI FUSE
NCA WIRE
POWER- TRAIN CONTROL MODULE (PCM) (BELOW CENTER OF I/P)
PULL- IN HOLD
RED WIRE
RED/WHT WIRE
REMOTE ANTI-THEFT PERSONALITY (RAP) MODULE (LEFT REAR OF VEHICLE)
ROOM FUSE
RUN WIRE
STARTER ASSEMBLY
SWITCH (ON CLUTCH PEDAL SUPPORT)
TRANS- MISSION RANGE (TR) SENSOR (LEFT SIDE OF ENGINE, ON TOP OF TRANS)
WHT WIRE
YEL WIRE
Go to component -> Starting circuit -> CLUTCH START SWITCH JUMPER (BEHIND LEFT SIDE OF I/P)
