Mercury Mountaineer II (2001-2005) class ii Wiring diagram
This page shows the only wiring diagram for the component.class ii, which is found in the car Mercury Mountaineer II (2001-2005). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram class ii (1 of 1)
1 2 3 4 TRAILER TOW CONNECTOR
BACK-UP LAMPS CIRCUIT
BATTERY CHARGE TRAILER TOW RELAY
BATTERY JUNCTION BOX (BJB) (LEFT SIDE OF ENGINE COMPT, AT FENDER APRON)
BLK WIRE
BLK/LT GRN WIRE
BLK/PNK WIRE
BLK/YEL WIRE
BRAKE PEDAL POSITION SWITCH (ABOVE BRAKE PEDAL)
BRN WIRE
BRN/WHT WIRE
BRN/YEL WIRE
BUMPER)
CENTRAL JUNCTION BOX (CJB) (BEHIND LEFT SIDE OF DASH)
CLASS II
CLASS III/IV
DK BLU WIRE
DK BLU/WHT WIRE
DK GRN WIRE
DK GRN/YEL WIRE
EXTERIOR LAMPS CIRCUIT
FUSE 13
FUSE 20
FUSE 23
FUSE 25
FUSE 27
GRY/YEL WIRE
HOT AT ALL TIMES
HOT IN RUN OR START
J/C 3
LEFT TURN TRAILER TOW RELAY
LT GRN WIRE
LT GRN/RED WIRE
ORG/ WIRE
PARKING LAMP TRAILER TOW RELAY
PNK/WHT WIRE
REAR AUXILIARY JUNCTION BOX (AJB) (RIGHT "D" PILLAR)
RED WIRE
REVERSING LAMP TRAILER TOW RELAY
RIGHT TURN TRAILER TOW RELAY
TAN/BLK WIRE
TRAILER ELECTRONIC BRAKE CONTROL MODULE (UNDER LEFT SIDE OF DASH PANEL)
TRAILER TOW CONNECTOR (CLASS III/IV) (AT REAR OF VEHICLE, BELOW
WHT WIRE
YEL WIRE
Go to component -> Trailer tow circuit, early production -> CLASS II
