Mercury Mountaineer I facelift (1997-2001) battery saver relay control Wiring diagram
This page shows the only wiring diagram for the component.battery saver relay control, which is found in the car Mercury Mountaineer I facelift (1997-2001). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram battery saver relay control (1 of 1)
ACCESSORY DELAY RELAY
BATTERY JUNCTION BOX (LEFT SIDE OF ENGINE COMPT, AT FENDER APRON)
BATTERY SAVER RELAY
BATTERY SAVER RELAY CONTROL
BLK WIRE
DK BLU WIRE
FUSE 4
FUSE 8
FUSE JUNCTION PANEL (LEFT SIDE OF VEHICLE, BELOW DASH)
GENERIC ELECTRONIC MODULE (BEHIND CENTER OF DASH) ACCY DELAY RELAY CONTROL
HOT AT ALL TIMES
LT BLU WIRE
LT BLU/BLK WIRE
LT GRN WIRE
NCA WIRE
ONE TOUCH OPEN/CLOSE ROOF OPENING PANEL MOTOR
ORG/ WIRE
PANEL CONTROL SWITCH (IN OVERHEAD CONSOLE)
RED WIRE
RELAY MODULE (BEHIND CENTER OF DASH)
ROOF OPENING
ROOF OPENING PANEL MOTOR (CENTER REAR OF ROOF)
SLIDE
SOLID STATE
TAN WIRE
TILT
TRANSMISSION SYSTEM, POWER WINDOWS SYSTEM
VIO WIRE
YEL WIRE
Go to component -> Power top/sunroof circuits -> BATTERY SAVER RELAY CONTROL
