Mercury Mariner II (2007-2010) near breakout to output shaft speed sensor) Wiring diagram
This page shows the only wiring diagram for the component.near breakout to output shaft speed sensor), which is found in the car Mercury Mariner II (2007-2010). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram near breakout to output shaft speed sensor) (1 of 1)
BLU/BRN WIRE
BLU/GRN WIRE
BLU/ORG WIRE
BLU/WHT WIRE
BRN/GRN WIRE
BRN/YEL WIRE
EPC
GRN WIRE
GRN/BRN WIRE
GRN/ORG WIRE
GRN/RED WIRE
GRN/VIO WIRE
GRN/WHT WIRE
GRY WIRE
GRY/RED WIRE
GRY/VIO WIRE
GRY/YEL WIRE
HTR-12
HTR-22
NEAR BREAKOUT TO OUTPUT SHAFT SPEED SENSOR)
OSS +
POWERTRAIN CONTROL MODULE (PCM) (IN RECESS ON UPPER CENTER OF FIREWALL)
SIGRTN
SSA
SSB
TCCH
TFT
TRS
TSS
VIO/GRN WIRE
VIO/GRY WIRE
WHT WIRE
WHT/ORG WIRE
WHT/VIO WIRE
YEL WIRE
YEL/GRN WIRE
YEL/VIO WIRE
Go to component -> Wiring diagram engine performance 3.0l (3 of 5) -> NEAR BREAKOUT TO OUTPUT SHAFT SPEED SENSOR)
