Mercedes-Benz E-class W124/S124/C124/A124 (1992-1997) power seats (seat regulating valve) wiring diagram
This page shows the only wiring diagram for the component.power seats (seat regulating valve), which is found in the car Mercedes-Benz E-class W124/S124/C124/A124 (1992-1997). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
power seats (seat regulating valve) wiring diagram (1 of 1)
4-DOOR, WAGON 2-DOOR
ACCESSORY EQUIPMENT CONNECTOR BLOCK
BLK/YEL WIRE
BLU WIRE
BRN WIRE
BRN/BLK WIRE
DOOR LOCK
ELECTRICAL CENTER (LEFT SIDE OF COMPONENT COMPARTMENT)
EXC. WAGON
FUSE A
FUSE C
GAS CAP ACTUATOR
GAS CAP FLAP
GRN WIRE
HOT AT ALL TIMES
HOT IN RUN OR START
LEFT FRONT DOOR ACTUATOR LOCK
LEFT REAR DOOR ACTUATOR
LID LOCK
LOCK
POWER SEATS (SEAT REGULATING VALVE)
RED/WHT WIRE
RIGHT FRONT DOOR ACTUATOR
RIGHT REAR DOOR ACTUATOR
SOLID STATE
SUPPLY PUMP (BELOW RIGHT SIDE OF REAR SEAT)
TRUNK/ TAILGATE LID LOCK ACTUATOR
UN LOCK
VACUUM ACTUATOR
WAGON
WARNING BUZZER SWITCH (DASH PANEL, RIGHT OF STEERING COLUMN)
YEL WIRE
Go to component -> Power door lock circuit -> POWER SEATS (SEAT REGULATING VALVE)
