Mazda RX-8 I (2003-2008) high pressure fuel wiring diagram
This page shows the only wiring diagram for the component.high pressure fuel, which is found in the car Mazda RX-8 I (2003-2008). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
high pressure fuel wiring diagram (1 of 1)
BLK WIRE
BLK/BLU WIRE
BLK/ORG WIRE
BLK/WHT WIRE
BLK/YEL WIRE
BLU/BLK WIRE
BLU/RED WIRE
BLU/WHT WIRE
CHECK CONNECTOR (IN RELAY, MAIN FUSE BLOCK)
COMPUTER DATA LINES SYSTEM
CONDENSER (UNDER LEFT REAR OF VEHICLE)
ENGINE FUSE
FUEL GAUGE SENDER UNIT (MAIN) (AT TOP LEFT SIDE OF
FUEL GAUGE SENDER UNIT (SUB) (AT TOP RIGHT SIDE OF FUEL TANK)
FUEL PUMP FUSE
FUEL PUMP RELAY (LOW PRESSURE) (CIRCUIT)
FUEL PUMP RESISTOR (AT RIGHT REAR OF ENGINE COMPT)
FUEL PUMP SPEED CONTROL RELAY
FUEL PUMP UNIT (AT TOP LEFT SIDE OF
FUEL SUCTION PIPE BRACKET (UNDER RIGHT REAR OF VEHICLE)
FUEL TANK
FUSE BLOCK (AT BATTERY)
GRN/BLK WIRE
HIGH PRESSURE FUEL
HOT AT ALL TIMES
HOT IN ON OR START
HOT IN RUN OR START
IG FUSE
IGNITION RELAY (IGNITION)
INSTRUMENT CLUSTER
J/C G-10
JC G-02
LT GRN WIRE
METER FUSE
MICROCOMPUTER
MIL IND FUEL GAUGE
NCA WIRE
RED/BLU WIRE
RED/GRN WIRE
RELAY, MAIN FUSE BLOCK (ON LEFT FRONT INNER FENDER PANEL)
WHT/BLU WIRE
WHT/GRN WIRE
WHT/RED WIRE
YEL/BLK WIRE
Go to component -> Wiring diagram engine performance 1.3l (3 of 5) -> HIGH PRESSURE FUEL
