Mazda Protege BH (1994-1999) (right rear engine compt) cruise control actuator wiring diagram
This page shows the only wiring diagram for the component.(right rear engine compt) cruise control actuator, which is found in the car Mazda Protege BH (1994-1999). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(right rear engine compt) cruise control actuator wiring diagram (1 of 1)
+IG
1.5L, 1.8L W/ A/T
1.8L
ANTILOCK BRAKE CONTROL MODULE (BEHIND LEFT SIDE OF DASH)
BLK WIRE
BLK/BLU WIRE
BLK/YEL WIRE
BLU/RED WIRE
BLU/WHT WIRE
BRN WIRE
BRN/WHT WIRE
CRUISE CONTROL MODULE (BEHIND RIGHT KICK PANEL)
DATA LINK CONNECTOR (LEFT FRONT INNER FENDER PANEL)
DATA LINK CONNECTOR 2 (BELOW LEFT SIDE OF DASH)
DISTRIBUTOR (LEFT FRONT OF ENGINE)
ENGINE CONTROLS SYSTEM
FAB
FBS
FP-
FSC
FUEL PUMP RELAY (UNDER CENTER RIGHT SIDE OD DASH)
GRY WIRE
HOT AT ALL TIMES ROOM FUSE (BEHIND LEFT SIDE OF DASH)
HOT IN RUN OR START
INSTRUMENT CLUSTER
INSTRUMENT CLUSTER AIR BAG IND
JC-4 (BEHIND RIGHT HEADLAMP)
JOINT BOX
KLN
LT GRN WIRE
MAIN RELAY (ON MAIN FUSE BLOCK)
METER FUSE
MICRO COMPUTER
POWERTRAIN CONTROL MODULE (UNDER CENTER OF DASH)
RED/GRN WIRE
SAS UNIT (BEHIND CENTER OF DASH)
TBS
TEN
VIO/WHT WIRE
WHT WIRE
WHT/RED WIRE
Go to component -> Computer data lines -> (RIGHT REAR ENGINE COMPT) CRUISE CONTROL ACTUATOR
