Mazda 6 GJ (2012-2015) push button start system w/o advanced keyless entry, Wiring diagram
This page shows the only wiring diagram for the component.push button start system w/o advanced keyless entry,, which is found in the car Mazda 6 GJ (2012-2015). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram push button start system w/o advanced keyless entry, (1 of 1)
0112-02
0112-03
2.5L
2.5L 3.7L
3.7L
3.7L 2.5L
AV C-58 0140-237
BLK WIRE
BLK/BLU WIRE
BLK/ORG WIRE
BLK/RED WIRE
BLU WIRE
BLU/GRY WIRE
BLU/RED WIRE
BRN WIRE
BRN/BLU WIRE
C-05 DIODE ANTI-THEFT (LOWER SYSTEM LEFT SIDE OF DASH)
C-56
CHT SENSOR (RIGHT FRONT OF ENGINE)
COMPUTER DATA LINES SYSTEM
ENG IG SAS FUSE LEFT SIDE OF FUSE DASH)
ENGINE CONTROLS SYSTEM
ENGINE COOLANT TEMPERATURE SENSOR (LEFT REAR OF ENGINE COMPT)
FAN CONTROL MODULE
FAN CONTROL MODULE RELAY
FUSE BLOCK (UNDER
GRN WIRE
GRN/WHT WIRE
GRY/RED WIRE
HOT AT ALL TIMES MAIN FUSE BLOCK (LEFT SIDE OF ENGINE COMPT) FAN FUSE
HOT IN RUN OR START
NCA WIRE
ORG/ WIRE
PCM (LEFT REAR OF ENGINE COMPT)
PUSH BUTTON START SYSTEM W/O ADVANCED KEYLESS ENTRY,
REFRIGERANT PRESSURE SENSOR (RIGHT FRONT OF ENGINE COMPT)
RELAY ENERGIZED
SENSOR GROUND
W/ ADVANCED KEYLESS ENTRY,
WHT WIRE
WHT/VIO WIRE
WHT/YEL WIRE
YEL WIRE
Go to component -> Cooling fan circuit -> PUSH BUTTON START SYSTEM W/O ADVANCED KEYLESS ENTRY,
