Lexus SC II (2001-2005) (in engine 4 harness, near breakout to positive battery cable) Wiring diagrams
This page contains all the electrical diagrams for the component. (in engine 4 harness, near breakout to positive battery cable), in which he is found in the car Lexus SC II (2001-2005). You can view various wiring diagrams where this component is used, as well as go to more detailed diagrams to see the complete connection and interaction in the system. All diagrams have links to quickly jump to the corresponding section with the component for easy viewing..
(in engine 4 harness, near breakout to positive battery cable) wiring diagram (1 of 2)
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 REOS TELIN
1 2 3 4 5 6 7 8 9 10 11 12 13 14 IG
A/C CONTROL ASSEMBLY (BEHIND CENTER OF DASH)
A/C ROOM TEMPERATURE SENSOR (BEHIND CENTER OF DASH)
A/C THERMISTOR (BEHIND CENTER OF DASH)
AIF AOF AMHPA AMHDR SG-4
AIR AOD AMCPA AMCDR
BLK WIRE
BLK/ORG WIRE
BLK/RED WIRE
BLK/WHT WIRE
BLK/YEL WIRE
BLOWER MOTOR (BEHIND LOWER RIGHT SIDE OF DASH)
BLOWER MOTOR CONTROLLER (BEHIND RIGHT SIDE OF DASH) SI +B GND M+ M-
BLU WIRE
BLU/ORG WIRE
BLU/RED WIRE
BLU/WHT WIRE
BLU/YEL WIRE
COMPUTER DATA LINES SYSTEM
DGS TSPA TR TPDR
DRIVER SIDE J/B (BEHIND LEFT KICK PANEL)
ENGINE ROOM 1 R/B (ON RIGHT SIDE OF ENGINE COMPT, BEHIND STRUT TOWER)
EXHAUST GAS SENSOR (AT LEFT FRONT OF ENGINE COMPT)
FAN FUSE
FAN-2 FUSE
GAS
GRN WIRE
GRN/BLK WIRE
GRN/ORG WIRE
GRN/RED WIRE
GRN/WHT WIRE
GRN/YEL WIRE
GRY WIRE
HAZD SG-1 TSDR TE SG-2
HEATER FUSE
HOT AT ALL TIMES
HOT IN ON OR START
IH (UNDER STEERING COLUMN)
INSTRUMENT PANEL J/B (BEHIND UPPER CENTER OF DASH)
JUNCTION CONNECTOR 14 (BEHIND RIGHT SIDE OF DASH)
LT GRN WIRE
LT GRN/BLK WIRE
MPX+ GND
MPX-IG FUSE
MULTI-DISPLAY
OPEN CLS SWE BLW
OPN
ORG/ WIRE
PNK EMOP WIRE
PNK WIRE
POWER TOPS SYSTEM
RED WIRE
RED/BLK WIRE
RED/BLU WIRE
RED/GRN WIRE
RED/WHT WIRE
SG-3
TELEPHONE COMPUTER (CENTER REAR OF LUGGAGE COMPARTMENT)
TILT
TPO
TPPA MPX-
TSL
TSR
VIO WIRE
VIO/WHT WIRE
WHT WIRE
WHT/BLK WIRE
WHT/BLU WIRE
WHT/GRN WIRE
WHT/RED WIRE
YEL WIRE
YEL/BLK WIRE
YEL/GRN WIRE
Go to component -> Automatic a/c circuit (1 of 2) -> (IN ENGINE 4 HARNESS, NEAR BREAKOUT TO POSITIVE BATTERY CABLE)
(in engine 4 harness, near breakout to positive battery cable) wiring diagram (2 of 2)
10 24 25 RFC HP PRE
24 25 THW ETHW
BLK WIRE
BLU WIRE
BLU/WHT WIRE
DRIVER SIDE J/B (BEHIND LEFT KICK PANEL)
ED (REAR OF LEFT FENDER)
ENGINE CONTROL MODULE (AT LEFT SIDE OF ENGINE COMPT, IN ECU BOX)
ENGINE COOLANT TEMPERATURE SENSOR (ON TOP RIGHT SIDE OF ENGINE)
ENGINE ROOM 1 R/B (ON RIGHT SIDE OF ENGINE COMPT, BEHIND STRUT TOWER)
ENGINE ROOM 2 R/B
FAN FUSE
FAN FUSE 2
FAN RELAY (ON LEFT SIDE OF ENGINE COMPT, FORWARD OF STRUT TOWER)
GND(S) GND(M)
HEATER FUSE
HOT AT ALL TIMES
HOT IN ON OR START
IF (AT LEFT KICK PANEL)
II (ON LEFT SIDE DASH BRACE) ED (REAR OF LEFT FENDER)
JUNCTION CONNECTOR 14 (IN ENGINE ROOM 2 R/B)
JUNCTION CONNECTOR 3 (IN ENGINE ROOM 2 R/B)
JUNCTION CONNECTOR 8 (BEHIND LEFT END OF DASH)
RED WIRE
VIO WIRE
WHT WIRE
WHT/BLK WIRE
WHT/GRN WIRE
YEL WIRE
Go to component -> Cooling fan circuit -> (IN ENGINE 4 HARNESS, NEAR BREAKOUT TO POSITIVE BATTERY CABLE)
