Lexus RX III facelift (2012-2015) multi information display assembly Wiring diagram
This page shows the only wiring diagram for the component.multi information display assembly, which is found in the car Lexus RX III facelift (2012-2015). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram multi information display assembly (1 of 1)
13 5 TX- TX+
22 10 20 PNK WIRE
5 15 PNK ATX+ ATX- WIRE
7 19 TX+ TX- PNK WIRE
7 8 TX+ TX-
9 10 PNK TX+ TX- WIRE
9 10 TXM+ TXM-
BLK WIRE
BLU WIRE
BRN WIRE
GRN WIRE
GRY WIRE
HEATER CONTROL PANEL (RADIO
LEFT "C" PILLAR)
LEFT BLIND SPOT MONITOR SENSOR (BEHIND LEFTSIDE OF REAR FASCIA)
LIN
LIN 1
LT BLU WIRE
METER MIRROR SUB-ASSEMBLY (LEFT SIDE OF DASH)
MULTI INFORMATION DISPLAY ASSEMBLY
MULTI- DISPLAY ASSEMBLY
MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY
NAVIGATION RECEIVER ASSEMBLY (W/ NAVIGATION)
PNK WIRE
RADIO RECEIVER ASSEMBLY
RECEIVER ASSEMBLY)
RED WIRE
RIGHT BLIND SPOT MONITOR SENSOR (BEHIND RIGHT SIDE OF REAR FASCIA)
ST-PLUG
STEREO COMPONENT AMPLIFIER ASSEMBLY (LUGGAGE COMPT)
VIO WIRE
W/O NAVIGATION, RADIO, DISPLAY RECEIVER TYPE
W/O NAVIGATION, W/ RADIO, DISPLAY RECEIVER TYPE
WHT WIRE
WHT/BLK WIRE
YEL WIRE
Go to component -> Computer data lines circuit (3 of 3) -> MULTI INFORMATION DISPLAY ASSEMBLY
