Lexus LS IV (2006-2012) pre-collision system Wiring diagram
This page shows the only wiring diagram for the component.pre-collision system, which is found in the car Lexus LS IV (2006-2012). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram pre-collision system (1 of 1)
+B PGND
1 2 3 4 5 6 7 8 9 10 MOR- MOR+ MOL+ MOL-
1 2 3 4 5 6 7 8 CAN H CAN L
20 21 18 COMPUTER DATA LINES SYSTEM ES
36 26 6 IGB SGND FCAS
9 8 CANH CANL
BLK WIRE
BLU WIRE
BRN WIRE
CANCEL SWITCH ASSEMBLY
CENTER DRIVER JUNCTION BOX 3 SIDE J/B (RIGHT SIDE (LEFT END OF DASH) OF DASH)
COMBINATION METER
COMPUTER DATA LINES SYSTEM
DRIVING SUPPORT ECU ASSEMBLY (LEFT KICK PANEL)
ENGINE ROOM J/B 2 (RIGHT SIDE OF LUGGAGE COMPT)
FUSE
GRN WIRE
HOT AT ALL TIMES LUGGAGE ROOM J/B PSB FUSE (LEFT SIDE OF LUGGAGE COMPT)
HOT W/
HOT W/ RR
J/C
LEFT FRONT PRE-COLLISION SEAT BELT MOTOR (BASE OF LEFT "B" PILLAR)
MICRO COMPUTER
MILLIMETER WAVE RADAR SENSOR ASSEMBLY (CENTER OF FRONT GRILLE)
P-J/B FUSE
PASSENGER SIDE J/B (RIGHT END OF DASH)
PCS IND
POWER SUPPLY
PRE-COLLISION SYSTEM
RED WIRE
RIGHT FRONT PRE- COLLISION SEAT BELT MOTOR
SEAT BELT CONTROL ECU (LEFT SIDE OF LUGGAGE COMPT)
SGND IGB
SKID CONTROL ECU ASSEMBLY (LEFT REAR OF ENGINE COMPT)
WHT WIRE
WHT/BLK WIRE
YEL WIRE
Go to component -> Pre-collision circuit -> PRE-COLLISION SYSTEM
