Lexus IS II facelift (2008-2010) switch tilt, telescopic Wiring diagram
This page shows the only wiring diagram for the component.switch tilt, telescopic, which is found in the car Lexus IS II facelift (2008-2010). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram switch tilt, telescopic (1 of 1)
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 TIM- +B
BLK WIRE
COMPUTER DATA LINES SYSTEM
DOWN
ECU-IG RH FUSE
ENGINE ROOM R/B 1 (RIGHT REAR OF ENGINE COMPT)
GRN WIRE
GRN/RED WIRE
GRN/WHT WIRE
GRY WIRE
HEADLAMP DIMMER SWITCH ASSEMBLY
HOT AT ALL TIMES
HOT AT ALL TIMES RIGHT COWL SIDE J/B (RIGHT END OF DASH) TI, TE FUSE
HOT IN ON OR START
JUNCTION
LEFT COWL SIDE J/B (LEFT END OF DASH)
LONG
LT BLU WIRE
LT GRN WIRE
MPX-B FUSE
MSW
ORG/ WIRE
PNK WIRE
RED WIRE
RIGHT COWL SIDE J/B (RIGHT END OF DASH)
SHORT
SWITCH TILT, TELESCOPIC
TELESCOPIC MOTOR
TELESCOPIC SENSOR
TEM+ TEM-
TILT MOTOR (AT STEERING COLUMN)
TILT, TELESCOPIC ECU (ON STEERING COLUMN)
TIM
TIS
VCE TES
VCI
VCI TIS IG ECUB TIM+ GND
VIO WIRE
WHT/BLK WIRE
WINDSHIELD WIPER SWITCH ASSEMBLY
Go to component -> Power tilt steering column circuit -> SWITCH TILT, TELESCOPIC
