Lexus IS II facelift (2008-2010) 3 2 1 pnk canh canl gnd Wiring diagram
This page shows the only wiring diagram for the component.3 2 1 pnk canh canl gnd, which is found in the car Lexus IS II facelift (2008-2010). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram 3 2 1 pnk canh canl gnd (1 of 1)
1 3 9 10 2 IG BAT CANL CANH ESS
3 2 1 PNK CANH CANL GND WIRE
BLK WIRE
COMPUTER DATA LINES SYSTEM
CRUISE CONTROL) (LEFT SIDE OF TRUNK)
ECM (ENGINE CONTROL MODULE) (LEFT FRONT OF ENGINE COMPT)
ENGINE COMPT)
HOT AT ALL TIMES
LEFT COWL SIDE J/B (LEFT END OF DASH)
LH ECU-IG FUSE
LH-IG 1 RELAY
LH-IG 2 RELAY
LH-IG FUSE
LT GRN WIRE
PNK WIRE
POWER STEERING ECU (RIGHT REAR OF
RED WIRE
SEAT BELT CONTROL ECU (W/ DYNAMIC RADAR
STEERING SENSOR (UNDER LEFT SIDE OF DASH)
WHT WIRE
WHT/BLK WIRE
YAW RATE SENSOR (UNDER CENTER CONSOLE)
YEL WIRE
Go to component -> Anti-lock brakes circuit (3 of 3) -> 3 2 1 PNK CANH CANL GND WIRE
