Lexus GS IV (2011-2015) humidity sensor (a/c thermistor assembly) (in overhead console) wiring diagram
This page shows the only wiring diagram for the component.humidity sensor (a/c thermistor assembly) (in overhead console), which is found in the car Lexus GS IV (2011-2015). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
humidity sensor (a/c thermistor assembly) (in overhead console) wiring diagram (1 of 1)
+B GND SI
1 2 ACPE ACPB
A/C AMPLIFIER (CENTER OF DASH)
A/C W/P FUSE FAN 1 FUSE
BLK WIRE
BLU WIRE
BRN WIRE
COMPUTER DATA LINES SYSTEM
COOLING FAN ECU (ON COOLING FAN MOTOR)
DGS
E.F.I ENGINE COOLANT TEMPERATURE SENSOR (TOP RIGHT REAR OF ENGINE)
ECM (ENGINE CONTROL MODULE) (LEFT SIDE OF ENGINE COMPT)
ENGINE ROOM J/B 1 (LEFT SIDE OF ENGINE COMPT)
ENGINE ROOM R/B 1 (LEFT SIDE OF ENGINE COMPT)
FAN 1 RELAY
GRN WIRE
GRY WIRE
HOT AT ALL TIMES
HTR FUSE PTC 1 FUSE FUSE
HUMIDITY SENSOR (A/C THERMISTOR ASSEMBLY) (IN OVERHEAD CONSOLE)
IDH
INVERTER W/ CONVERTER (RIGHT REAR CORNER OF ENGINE COMPT)
ION GENERATOR 1 (IF EQUIPPED) (CENTER OF DASH)
LT BLU WIRE
LT GRN WIRE
ORG/ WIRE
PCL
PTC 1 RELAY (IF EQUIPPED)
PTC 2 +
PTC 2 RELAY (IF EQUIPPED)
RED WIRE
RFC
RIGHT END OF DASH)
SEATS SEATS SYSTEM SYSTEM
SG-2
SG-3
SG-4
SG-5
TFG
TNG
VIO WIRE
WHT WIRE
WHT/BLK WIRE
WHT/BLU WIRE
YEL WIRE
Go to component -> Automatic a/c circuit (2 of 3) -> HUMIDITY SENSOR (A/C THERMISTOR ASSEMBLY) (IN OVERHEAD CONSOLE)
