Lexus GS III facelift (2007-2011) seat belt gateway ecu 2 Wiring diagram
This page shows the only wiring diagram for the component.seat belt gateway ecu 2, which is found in the car Lexus GS III facelift (2007-2011). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram seat belt gateway ecu 2 (1 of 1)
BLK WIRE
CENTER STOP LAMP
CONTROL ECU
FUEL LID OPENER MOTOR
FUEL SUCTION PUMP, GAUGE ASSEMBLY
JUNCTION
JUNCTION CONNECTOR
LEFT FRONT DOOR ECU
LEFT FRONT LEFT SEAT BACK FRONT CLIMATE SEAT CONTROL HEATER BLOWER
LEFT FRONT SEAT CUSHION CLIMATE CONTROL BLOWER
LEFT FRONT SEAT INNER BELT
LEFT REAR ABSORBER CONTROL ACTUATOR
LEFT REAR COMBINATION LAMP
LEFT REAR DOOR ECU
LEFT REAR SEAT INNER BELT
LICENSE PLATE LAMP
LUGGAGE COMPARTMENT DOOR CLOSER
LUGGAGE COMPARTMENT DOOR LOCK CYLINDER
LUGGAGE COMPARTMENT DOOR STRIKER SWITCH
LUGGAGE LEFT REAR COMPARTMENT COMBINATION DOOR OPENER LAMP SWITCH
LUGGAGE ROOM J/B (LEFT
LUGGAGE ROOM J/B ECU
REAR SUNSHADE RELAY
RELAY
RIGHT REAR COMBINATION LAMP
SEAT BELT GATEWAY ECU 2
SIDE OF LUGGAGE COMPT)
SPOOL
WHT WIRE
WHT/BLK WIRE
WIRING HARNESS)
Go to component -> Ground distribution circuit (6 of 8) -> SEAT BELT GATEWAY ECU 2
