Lexus GS III facelift (2007-2011) camshaft engine control control motor module (bank 1) wiring diagram
This page shows the only wiring diagram for the component.camshaft engine control control motor module (bank 1), which is found in the car Lexus GS III facelift (2007-2011). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
camshaft engine control control motor module (bank 1) wiring diagram (1 of 1)
AIR FUEL RATIO SENSOR (BANK 2 SENSOR 1) SHIELD
BLK WIRE
BRN WIRE
CAMSHAFT CONTROL MOTOR (BANK 1)
CAMSHAFT CONTROL MOTOR (BANK 2)
CAMSHAFT CONTROL TRANSMISSION MOTOR CONTROL (BANK 2) ECU
CAMSHAFT ENGINE CONTROL CONTROL MOTOR MODULE (BANK 1)
CANISTER PUMP MODULE
DATA LINK CONNECTOR 3
DISTANCE CONTROL ECU
ENGINE CONTROL MODULE
ENGINE INJECTOR CONTROL DRIVER 1 MODULE
ENGINE OIL LEVEL SENSOR
GRN WIRE
IGNITION COIL 1
IGNITION COIL 2
IGNITION COIL 3
IGNITION COIL 4
IGNITION COIL 5
IGNITION COIL 6
IGNITION COIL 7
IGNITION COIL 8
INJECTOR DRIVER 2
INJECTOR DRIVER 2 SHIELD
INJECTOR KNOCK DRIVER 1 SENSORS SHIELD (BANK 1, 2 SENSOR 2) SHIELD
JUNCTION CONNECTOR
LEFT CENTER J/B (BEHIND RIGHT SIDE OF DASH)
LEFT IGNITION NOISE FILTER
MILLIMETER WAVE RADAR SENSOR
NCA WIRE
RIGHT CENTER J/B (BEHIND RIGHT SIDE OF DASH)
RIGHT IGNITION NOISE FILTER
SPIRAL CABLE
TRANSMISSION CONTROL ECU
TRANSMISSION CONTROL SWITCH
WHT WIRE
WHT/BLK WIRE
YEL WIRE
Go to component -> Ground distribution circuit (2 of 8) -> CAMSHAFT ENGINE CONTROL CONTROL MOTOR MODULE (BANK 1)
