Land Rover Range Rover IV (2012-2017) static bending led array wiring diagram
This page shows the only wiring diagram for the component.static bending led array, which is found in the car Land Rover Range Rover IV (2012-2017). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
static bending led array wiring diagram (1 of 1)
ANTI-THEFT SYSTEM
BATTERY JUNCTION BOX
BLK WIRE
BLU WIRE
BLU/GRN WIRE
BLU/ORG WIRE
BLU/RED WIRE
BODY CONTROL MODULE (BCM)
BRAKE DIAG DI SW FRONT
BRAKE DIAGNOSTIC SWITCH
BRAKE PEDAL SWITCH
BRAKE SW CAN SIG
BRK SW
BRN WIRE
BRN/BLU WIRE
BRN/GRN WIRE
BRN/RED WIRE
BRN/YEL WIRE
CENTRAL JUNCTION BOX
COMPUTER DATA LINES SYSTEM
DI LED ARRAY
ENGINE CONTROL MODULE (ECM)
FUSE 31
FUSE 51
FUSIBLE LINK 7
GRN/ORG WIRE
GRY/BLU WIRE
GRY/ORG WIRE
GRY/PPL WIRE
HAZARD SW
HAZARD SWITCH
HOT AT ALL TIMES
HOT W/ IGNITION RELAY ENERGIZED
HS CAN-H
HS CAN-L
I S BRK SW
I S BRKOS
INSTRUMENT CLUSTER
INTEGRATED CONTROL PANEL
LEFT HEADLAMP
LH CORN LIGHT
LH FRONT POSI
LIN 1
LIN 2
LIN 3
MS CAN-H
MS CAN-L
MS MS HS HS CAN CAN CAN GND
PPL/BRN WIRE
PPL/GRN WIRE
PPL/ORG WIRE
PWR
RAIN/LIGHT SENSOR
RIGHT END OF DASH)
RIGHT HEADLAMP
SIDE LIGHT LED ARRAY
STATIC BENDING LED ARRAY
STEERING WHEEL MODULE
STOP LAMP SWITCH
TRAILER BRAKE CONTROL MODULE
VBATT
WHT WIRE
YEL/ORG WIRE
YEL/PPL WIRE
Go to component -> Exterior lamps circuit (1 of 2) -> STATIC BENDING LED ARRAY
