Land Rover Discovery II (1998-2004) idle solenoid suppressor Wiring diagram
This page shows the only wiring diagram for the component.idle solenoid suppressor, which is found in the car Land Rover Discovery II (1998-2004). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram idle solenoid suppressor (1 of 1)
BLK WIRE
BLK/BLU WIRE
BLK/GRN WIRE
BLK/YEL WIRE
BLU/GRN WIRE
BRN WIRE
BRN/ORG WIRE
BRN/PNK WIRE
BRN/RED WIRE
CAMSHAFT POSITION SENSOR (LOWER RIGHT FRONT OF ENG)
CRANKSHAFT POSITION SENSOR (LOWER LEFT REAR OF ENG)
FUEL PUMP
GRN WIRE
GRN/PNK WIRE
GRY/BLU WIRE
GRY/GRN WIRE
GRY/LT GRN WIRE
IDLE SOLENOID SUPPRESSOR
LEAK DETECTION PUMP (UNDER RIGHT SIDE OF VEHICLE)
LEFT BANK KNOCK SENSOR (LOWER LEFT SIDE OF ENG, NEAR ENG MOUNT)
MASS AIRFLOW SENSOR (ON INTAKE AIR DUCT)
NCA WIRE
PNK/BLK WIRE
PNK/ORG WIRE
PNK/WHT WIRE
PURGE CONTROL VALVE (ON RIGHT FRONT OF ENGINE)
RED WIRE
RED/BLK WIRE
RIGHT BANK KNOCK SENSOR (LOWER RIGHT SIDE OF ENG, NEAR STARTER)
TEMPERATURE SENSOR
WHT WIRE
WHT/PPL WIRE
YEL/BLK WIRE
YEL/BLU WIRE
YEL/BRN WIRE
YEL/LT GRN WIRE
Go to component -> Wiring diagram engine performance 4.0ls (2 of 3) -> IDLE SOLENOID SUPPRESSOR
