Kia Sportage II facelift (2008-2010) pnk on/start input ground ground od dcc Wiring diagram
This page shows the only wiring diagram for the component.pnk on/start input ground ground od dcc, which is found in the car Kia Sportage II facelift (2008-2010). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram pnk on/start input ground ground od dcc (1 of 1)
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 PULSE GEN A PULSE GEN B
ATM FUSE
ATM RELAY
ATM SOLENOID VALVE (TOP OF TRANSAXLE)
AUTO CRUISE
BLK WIRE
BLK/ORG WIRE
BLU WIRE
CONNECTOR
CRUISE CONTROL MODULE (ON RIGHT FENDER, BEHIND STRUT TOWER)
ECU FUSE
ECU-B FUSE
ENGINE ROOM JUNCTION BOX (IN LEFT FRONT CORNER OF ENGINE COMPT)
FLASH SOURCE
GRN/BLK WIRE
GRN/ORG WIRE
GRY WIRE
HOT AT ALL TIMES
HOT IN ON OR START
I/P JUNCTION BOX (UNDER LEFT END OF DASH)
I/P-E
JOINT CONNECTOR
MEMORY PWR
OIL TEMP +
ORG/ WIRE
PNK ON/START INPUT GROUND GROUND OD DCC WIRE
PNK ON/START INPUT GROUND GROUND WIRE
PNK WIRE
PULSE GENERATOR "A" (TOP OF TRANSAXLE)
PULSE GENERATOR ``B" (TOP RIGHT REAR OF ENGINE)
PWM SIGNAL
RED WIRE
RED/ORG WIRE
SENSOR
SENSOR GND O/T
TRANSMISSION CONTROL MODULE (TCM) (UNDER LEFT SIDE OF DASH)
WHT WIRE
Go to component -> 2.7l, a/t circuit (1 of 2) -> PNK ON/START INPUT GROUND GROUND OD DCC WIRE
