Kia Sedona II facelift (2010-2014) yaw rate sensor (behind center of dash) low high wiring diagram
This page shows the only wiring diagram for the component.yaw rate sensor (behind center of dash) low high, which is found in the car Kia Sedona II facelift (2010-2014). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
yaw rate sensor (behind center of dash) low high wiring diagram (1 of 1)
ABS
ABS CONTROL MODULE (AT LEFT REAR OF ENGINE LOW HIGH COMPARTMENT)
BLK WIRE
BLU WIRE
BRN WIRE
CAN RESISTOR (BEHIND LEFT CENTER OF DASH)
CLG-A
ESC
ESC MODULE
GRN WIRE
HIGH HIGH
J/C JERA (LEFT REAR OF ENGINE COMPT)
J/C JERE (LEFT FRONT CORNER OF ENGINE COMPT)
J/C JERL
J/C JMRK (BEHIND CENTER OF DASH)
LOW LOW
MULTIPURPOSE CHECK CONNECTOR (LEFT FRONT OF ENGINE COMPT)
ORG/ WIRE
PCM
RED WIRE
WHT WIRE
WHT/ORG WIRE
YAW RATE SENSOR (BEHIND CENTER OF DASH) LOW HIGH
YEL WIRE
Go to component -> Computer data lines circuit (2 of 2) -> YAW RATE SENSOR (BEHIND CENTER OF DASH) LOW HIGH
