Kia Sedona II facelift (2010-2014) joint connector jmd Wiring diagram
This page shows the only wiring diagram for the component.joint connector jmd, which is found in the car Kia Sedona II facelift (2010-2014). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
Wiring diagram joint connector jmd (1 of 1)
"R" POSITION OUTPUT
23 BEC-FC
47 CLG-A POSITION SW
AUDIO
B-CAN
B-CAN B-CAN HIGH LOW
B-CAN B-CAN LOW HIGH
B-CAN HIGH
B-CAN LOW
BACK UP LAMP
BACK UP SIG OUT
BCM-FE
BCM-IF
BCM-IM
BEC-FF
BEC-IF
BLK WIRE
BLU WIRE
BLU/ORG WIRE
BRN WIRE
BRN/BLK WIRE
C-CAN C-CAN LOW HIGH
C-CAN HIGH
C-CAN LOW
COMPUTER DATA LINES SYSTEM
ELECTRO CHROMIC MIRROR (FRONT CENTER OF ROOF)
ENG FUSE
ENGINE COMPT) B-CAN LOW HIGH
FAM (FRONT AREA MODULE) (LEFT FRONT OF
GRN WIRE
GRN/BLK WIRE
GRY WIRE
HOME LINK (ECM, HOME LINK) (CENTER FRONT OF ROOF)
HOT AT ALL TIMES
HOT IN ON OR START
INSTRU- MENT CLUSTER
IPM (INSTRUMENT PANEL MODULE) (BEHIND LEFT SIDE OF DASH)
IPS
JOINT CONNECTOR JMD
LEFT REAR COMBINATION LAMP
MEMORY FUSE
MICOM
ORG/ WIRE
PCM
PNK ON/START INPUT WIRE
PNK WIRE
PNK/BLK WIRE
POSITION SW
R INPUT
RAM (REAR AREA MODULE) (LEFT REAR CORNER OF VEHICLE)
REAR PARKING ASSIST CONTROL MODULE (NEAR BASE OF RIGHT "C" PILLAR)
RED WIRE
RED/BLK WIRE
RIGHT REAR COMBINATION LAMP
SHUNT CONNECTOR
SIG (1)
SIG (2)
SIG 3
SIG 4
TRANSAXLE RANGE SWITCH (ON TOP OF TRANSAXLE)
W/O LCD W/ LCD
WHT WIRE
YEL WIRE
Go to component -> Backup lamps circuit -> JOINT CONNECTOR JMD
